C Whole Server Migration for Windows

This appendix describes the procedure to enable a virtual IP address for Windows XP systems.

C.1 Using Windows Control Panel

This procedure assumes the system is Windows XP, configured for static IP addresses.

Go to Control Panel.
Select Network and Internet Connections.
Select Network Connections then select Local Area Connection.
Choose Internet Protocol (TCP / IP) and click the Properties button.
In the next window, click Advanced at the bottom of the dialog.
Click Add next to the IP addresses to add an IP address with a corresponding sub-net mask. (Available only if the system is configured for static IPs.)

C.2 Using the netsh Command Line

The command line method is to use netsh. For example:

netsh interface ip show address <interface>
netsh interface ip add address <interface> <address> <netmask>
netsh interface ip delete address <interface> addr=<address>

The following commands are available:

Table C-1 Application URLs

Application	URL
?	Displays a list of commands.
add	Adds a configuration entry to a table
delete	Deletes a configuration entry from a table.
dump	Displays a configuration script.
help	Displays a list of commands.
ip	Changes to the `netsh interface ip' context.
ipv6	Changes to the `netsh interface ipv6' context.
portproxy	Changes to the `netsh interface portproxy' context.
reset	Resets information.
set	Sets configuration information
show	Displays information.

The following sub-contexts are available:

ip ipv6 portproxy

To view Help for a command, type the command followed by a space, and then ?.